Burst Pipe Repair in Arden, NY

Burst Pipe Repair in Arden: what the job involves

A burst pipe in Arden almost never fails in the middle of a straight run. It goes at a fitting, at a spot where the pipe was strapped too tight, or in an unheated crawl space, garage wall or attic run that dropped below freezing. Our first job is the shut-off, our second is finding the actual failure rather than the place where water finally showed up, which is often several feet away and one floor down.

Repairs are made in the same material where that makes sense and upgraded where it does not. Copper gets cut back to clean pipe and sweated or pressed; failing polybutylene and old galvanized get replaced with PEX rather than patched, because a patch on a line that is failing from age just moves the next burst a few feet along. We pressure test before we close anything up.

When to call us

• Sudden loss of pressure across the whole house
• Water staining a ceiling or running down inside a wall
• Hissing or rushing sound with every tap closed
• A pipe that froze and then started leaking as it thawed

Arden and the area around it

A lot of Arden properties still have the original sewer lateral running out to the street. Clay opens at the joints, cast iron scales down to a fraction of its bore, and Orangeburg deforms and collapses. A camera survey tells you which one you have and roughly how long it has left, which turns an emergency into a planned expense.

We would rather talk you out of work you do not need. If a water heater has a dead element and a sound tank, that is a repair, not a replacement. If a drain has been cabled three times in two years, cleaning it again is not the answer and we will say so.